Photo/BoatingLocal, Tom Richardson

By Capt. John Galvin

While striped bass, bluefish and fluke get the lion’s share of inshore angling attention in New England, it’s the humble tautog that often marks the start of the saltwater fishing season for those who can’t wait to wet a line. In southern New England, ‘tog start to move inshore around mid-April, or when the water temperature hits the mid-40s. By the time the first dandelions start to pop up on lawns, the fishery should be in full swing.

Where to Find Them

This chart shows 3 spots in Nantucket Sound that hold good numbers of 'tog in the spring.

As most anglers know, tautog like to hang around structure, including rocks, mussel beds, wrecks and pilings. Isolated rocks and wrecks on an otherwise flat and featureless bottom are always prime spots, serving as oases for crabs, worms and other ‘tog food. For example, in Massachusetts, mostly sandy Nantucket Sound contains several wrecks that produce excellent spring ‘tog fishing (the 2 wrecks off Oak Bluffs, near Hedge Fence shoal, are perennial hot spots).

Capt. Nat Chalkley of Get the Net charters shows off a nice spring tautog. Photo by Capt. John Galvin

The waters off Gay Head (Aquinnah) on Martha’s Vineyard are ‘tog utopia in the spring, as the massive boulders and rock piles that litter the bottom here hold lots of crabs and mussels, and give the fish plenty of places to hide from predators. The same holds true for the Sound side of the Elizabeth Islands, as well as Woods Hole, Robinsons Hole and Quicks Hole.

In Buzzards Bay, you’ll find no shortage of prime ‘tog structure. Cleveland Ledge, Mishaum Ledge, the Bow Bells, Nye Ledge and Bird Island Reef are 5 well-known hot spots. As such, they draw large crowds of fishermen, including commercial pin-hookers and partyboat anglers, who can quickly remove the biggest fish from a spot. Once that happens, you’ll need to pick through a lot of small ‘tog before landing a keeper.

Find a Honey Hole

The rocky bottom off Martha's Vineyard's Gay Head holds tons of tautog.

You’ll do much better if you make an effort to seek out smaller, harder-to-find spots that receive less pressure. Study a chart to locate some reefs or wrecks in 10’ to 40’ of water, then check them out in person. To find these structure spots, you’ll need a depthsounder. When you reach the general area, idle in progressively wider circles while watching the screen for signs of structure and fish. Once you find the highest part of the structure, deploy a marker buoy set for the corresponding depth.

Anchoring Tips

Matt Nugent displays a 'tog taken in Buzzards Bay. Photo BoatingLocal/Tom Richardson

Anchoring is generally preferred in ‘tog fishing—and precise anchoring is the key to success. Anchoring not only keeps the boat in position over the part of the structure that holds the most fish, it allows the angler to keep his line vertical and hold bottom more effectively.

Deploy the anchor well upcurrent or upwind of the reef or wreck and let out line until the boat is directly over the highest part of the structure. If the wind is blowing, you may need to set a second anchor off the stern to keep the boat from swinging. This will keep you over the best spot and help prevent snags. By the way, you will be well served to buy a wreck anchor (the kind with bendable tines) for tautog fishing.

Once the boat is anchored, each angler onboard should fish from a different part of the boat. Sometimes a matter of just a few feet can make a big difference. You can also fish different parts of the structure by letting out or taking in the anchor line, or tying it off to a midships cleat to “sail” the boat sideways.

You can learn more about anchoring of bottom fish by CLICKING HERE.

Click to read Anchoring Over Structures.

Depth & Current Considerations

Five good spots to catch 'tog in Upper Buzzards Bay.

As any serious ‘tog fisherman will tell you: if you don’t get a bite after 10 minutes, you’re probably in the wrong spot. Re-anchor over another part of the structure, or run to a new area altogether. Sometimes it’s a matter of finding the right depth zone or a rock pile that hasn’t been picked clean by other anglers, so keep hitting different spots until you score.

If you are clearly marking fish on your sounder, but not hooking up, check the tide. Like most fish, tautog feed best in moving water, and tend to shut off during slack tide. The current doesn’t need to be moving fast, but it has to be moving. Sometimes it means waiting for the current to pick up before the fish start feeding. Be aware that you will need to use heavier sinkers as the current increases to keep your bait on the bottom, so bring a variety of sizes ranging from 2 to 6 ounces.

Best Baits & Gear

Green crabs make excellent 'tog bait. Photo BoatingLocal/Tom Richardson

Fiddler crabs, green crabs, Asian crabs, clams, shrimp and seaworms all work for tautog, but the fiddlers and green crabs work best. Fiddler crabs are hard to come by here in New England unless you catch your own; however, most tackle shops carry green crabs. Cut the crabs in half or quarters, remove the legs and claws, and place a section on each hook, leaving the point exposed. Be sure to bring a lot of crabs, as ‘tog are expert bait stealers. When the fishing is hot, it’s easy for 4 anglers to go through a couple 5-gallon buckets of green crabs in a 6-hour session. Fortunately, any leftover crabs can be saved for the next trip.

There are a variety of bottom rigs for tautog, including specialized versions for fishing ultra-snaggy structure, but a basic dropper loop rig tied with heavy mono works fine in most situations. You can fish 2 droppers off the main leader, or just one, as shown in the following video. Just make sure to bring a bunch of extra rigs and sinkers, as you will lose a lot of gear to snags.

Learn how to tie a basic Dropper Loop Rig for tautog:

Braided line provides a big advantage when fishing for tautog, as it allows you to feel subtle bites and will help you set the hook in deep water. Braid is also thinner than monofilament of the same strength, so it forms less of a belly in strong current. This will help you prevent the fish from quickly ducking into the wreck or rocks once it’s hooked. Lastly, go with heavy line for ‘tog fishing (60-pound-test or more). This isn’t subtle sport, after all, and the fish are seldom line-shy.

The rod should be in the 7’ range and have a sensitive tip for detecting the subtle bites of a tautog. The tip should taper quickly to a stiff midsection and butt, providing enough backbone for pulling a big fish away from the bottom. Note that you don’t need a beefy boat rod for inshore tautog fishing. Indeed, a lighter stick rated for 15- to 30-pound line is much more fun and lets you appreciate the strength of these fish.

Related Article:

BoatingLocal: How to Tie a Basic Tautog Rig 

Related Video:

Watch a Video on Catching Tautog, CLICK HERE.

Share this Article On Facebook Twitter More...

Follow BoatingLocal:

Like BoatingLocal on Facebook. Follow us on Twitter. Receive our Daily RSS Feed.

Don’t forget to sign up for our monthly newsletter!

Each month our emailed newsletter keeps you up to speed on the top news items, videos, destinations, reviews and fishing articles on BoatingLocal, so you won’t miss a beat. It’s convenient, it’s free, and you can opt out at any time!