Video: Tying the Snell Knot

 

Snelling has long been the favored method for attaching the line or leader to a hook with an offset eye, as it allows for a straight pull when setting the hook. In this video, we’ll walk you through the steps for snelling a hook, both with and without a vise.

If you’ve never snelled a hook before, it may help to place the hook eye in a vise rather than hold it. This way you can use both hands to hold things in place while you practice tying the knot.

Here are the steps:

  1. Form a large loop in the line and pinch the top of the loop against the shank of the hook, where the standing and tag ends cross (if you are not using a vise, you can pass the line through the eye of the hook before forming the loop).
  2. Grasp one side of the loop and begin wrapping it around both sections of line and the shank, working towards the hook eye.
  3. Make 6 to 9 tight wraps around the shank. (The number of wraps depends on the strength of the leader; you’ll need fewer wraps with heavier line.)
  4. Gently pull on the tag end to close the loop.
  5. Gently pull the tag and standing sections in opposite directions to lightly tighten the knot.
  6. Push the wraps along the shank until they butt up against the eye of the hook.
  7. If necessary, rotate the wraps so the line exits on top of the shank.
  8. Pull the standing end of the line through the eye of the hook (if you are using a vise). Moisten the wraps and pull the tag and standing ends in opposite directions to firmly seat the knot. It often helps to grasp the tag end with pliers when tightening the knot.
  9. Trim the tag end and you’re done.

Now let’s do it without a vise.

  1. In this case, you can pass the tag end of the line through the eye before forming the loop.
  2. Again, pinch the top of the loop against the shank of the hook and begin making tight wrap around both sections of line and the shank, working towards the hook eye.
  3. Pull on the tag end to pull the loose line through the wraps and tighten the knot. Push the knot along the shank until it butts up against the eye of the hook.
  4. If necessary, rotate the knot so that the line exits on top of the shank.
  5. Pull firmly on both sections to fully tighten the knot.
  6. Trim the tag and you’re done.

Additional Information:

For more information on the Zing line of fishing products, go to Zing Fishing Tackle.

Special thanks:

Videographer: Nick Peck

Please share your comments below.